40mm Diameter - choose from two patterns - SPOTTED or DASH.
You will receive TWO PAIRS
IMPORTANT NOTE: If using the 17mm version to make stud earrings you must only use E6000 glue. You cannot use our hasulith glue as the acetone will eat though the paint layer base.
Dot may also be ordered with or without a hanging hole.
NOTE: etched areas will be see through.
Laser etched onto a clear glossy acrylic with a specialty two layer painted coating - that leaves a stunning dual-tone finish or choose mirror acrylic.
The shape will come with either a clear plastic or paper film on the front that will need to be removed.
© Crafty Cuts Laser - Original designs remain the property of Crafty Cuts Laser and may not be copied or reproduced by a third party or used for mold casting. See our FAQ “legal Bits” section for Allowed and Not Allowed uses.